| Power block is intended to switch the same ac voltage as is used to power the MAXI-BEAM, however both can switch any ac voltage that is lower than the supply voltage, as long as both AC circuits share a common neutral; Range depends on sensor; 4-Wire operation; These blocks are designed to handle the inrush current of AC inductive loads like motor starters and solenoids; There is no minimum load requirement, and they will interface directly to inputs of all AC programmable logic controllers (PLCs) |
| 50/60 Hz, 2 W exclusive of load input |
| 3/4 A maximum (derated to 1/2 A at 70 deg C) output |
| Maximum inrush 10 A for one second or 30 amps for one AC cycle (non-repeating) |
| On-state voltage drop of less than 2.5 VAC at full load |
| Off-state leakage current less than 100 uA |
| Range depends on sensor |
| Wiring chamber |
| 2 m length cable connection |
