Banner Engineering Multi-Beam® PBAT 3/4-Wire Power Block, Photoelectric Sensor, 105 to 130 VAC
Sensor Power Blocks, Bases & Receptacles
13304
MFG #: PBAT
BANNER®
103.63000
/ ea
- Catalog Number: PBAT
- Connection Type: Cable
- Country of Origin: USA
- Gross Weight Per Pack: 0.2700 lb
- Standards: CE Marked, CSA Approval, cULus Listed
- Suitable For Use With: Multi-Beam® Compact Modular Photoelectric Sensors
- Type: 3/4-Wire
- UNSPSC: 39121004
- UPC 11: 66248816386
- UPC 12: 66248816386
- Stock Status: NORMALLY STOCKED
- Brand: BANNER®
- Manufacturer: Banner Engineering Corp.
- Output Type: SPST Isolated Solid State Switch
- Sensor Type: Photoelectric
- Voltage Rating: 105 to 130 VAC
- Features
| Power block has an isolated solid-state output switch which may be used to switch either AC or DC; Range depends on sensor; 4-Wire operation; These power blocks usually should not be used to switch ac inductive loads since there is no capacity for inrush; It has enough capacity to switch many inductive DC loads like small relays and solenoids; Will interface directly to all AC programmable controller inputs; Since the saturation voltage of these power blocks is typically greater than 1 V, they should not be used to interface 5V dc logic circuits like TTL |
| 50/60 Hz input |
| 100 mA maximum (no inrush capacity), 200 VDC, 140 VAC maximum output |
| Less than 3 V full load on-state voltage drop |
| Less than 100 uA off-state leakage current |
| Range depends on sensor |
| Wiring chamber |
| 2 m length cable connection |